IP68, 50000~100000H lifespan
wide input voltage
Bridgelux/CREE chip LED
Die-casting aluminum housing
Anti-explosive DLC UL CE RoHS Approved LED Canopy Light with Bridgelux / CREE chip Meanwell Driver
Material of shell
Die Cast Aluminum,Temper Glass,Anti-Dust,
Water-proof,PCB Heat Index 2.0, with reflector
-40°C to 50°C
With reflector or not
60°x30°(RF) / 120°x120°
HLG MW driver with
protective Aluminum Housing
outside carton size
CESPE 100W VS 400W HPS in Mexcio
Detail information (30w-120w) 100w as sample
Apply in America
Power Drive Capacitor: Japan imported, Rubycon
- To ensure long lasting power drive.
Glass: 4mm(thickness) Super Strengthening Glass with 95% light transmit rate.
- To ensure minimum initial light loss while maintaining protection.
LED Chip : USA bridgelux chip BXCB45 or Cree XPE. Performing at 140lm-150lm @ 350ma (350ma is slightly over 1 watts).
Aluminum PCB board : Thickness 2.0mm with heat transmission index of 2.0.
Water proof Silicon: Top quality rubber with anti-low aging and burn-proof characteristic.
Ingress Protection Grade : IP68 (highest protection grade for waterproof and dustproof).
This is achieved thru materials used and unique design of the water proof body.
Reflective focuser Integrated to LED chip, therefore, secondary LENS is not needed to adjust angle.
In other word, no further initial light lost due to secondary LENS.
Integrated Reflective focuser’s angle on LED chip are 120°x 60°,(whole lamp angle : refer IES) which is designed to illuminate wide area and suitable for road lighting.
As a result, able to reduce the wattage of light fixture needed to illuminate the same area.
LENS Integrated with LED chip, therefore, secondary LENS is not needed to adjust angle.
Integrated LENS’s angle on LED chip are 140x 60 ° (refer IES for whole lamp angle), which is designed to illuminate wide area and suitable for road lighting.
As a result, able to reduce number of light fixture needed to illuminate the same area.